EZ- Shear Wall

EZ-Shear Wall is a software for practical design and detailing of reinforced concrete shear walls:

Design is performed based on ACI 318-08, ACI 318-11, ACI-318-14
Results are available for the two major orthogonal axis
Program develops full Bi-axial interaction diagrams based on design parameters
Allows for easy and practical specification of typical rebar and additional rebar at wall edges
Wall detailing can be chosen based on all compression bars confined, or only edge compresion bars confined
Interaction diagram can be zommed in to review results at any location

EZ- Shear Wall for (c)ETABS

EZ- Shear Wall for (c)ETABS includes all of EZ-Shear wall options in addition:

Resulting pier forces from ETABS v13 to v16 models can be imported and checked /designed in EZ-Shear Wall
Any pier from the model can be checked/designed
Results are reported in the form of Bi-axial interaction diagrams with all load cases /combos plotted
Allows the user to try different rebar configurations in seconds
An adequate design can be obtained in a fraction of the time of what it would take using ETABS general wall design procedure
Additional results include, steel ratio, depth of neutral axis, concrete shear design capacity, flexural D/C ratio, maximum compression fiber stress, required shear steel, and all governing load cases/combinations.

EZ- Pile Optimizer is a software for the design of symmetric pile groups

Pile groups design preferences can be defined parametrically based on maximum number of piles and spacing allowed in each othogonal direction
Analysis is performed for axial force plus moments in both directions
Forces can be aplied at any location, not only at centroid of pile group
Piles can have different compression and tension capacity
Results will include optimum pile group configuration based on design preferences and individual pile demands

EZ- Pile Regular is a software for the analysis of symmetric pile groups, results include:

Define pile group parametrically based on number of piles and spacing in each othogonal direction
Analysis is performed for axial force plus moments in both directions
Forces can be aplied at any location, not only at centroid of pile group
Piles can have different compression and tension capacity
Results include stress contours, indvidual pile results including demand/capacity ratios

EZ- Pile Irregular is a software for the analysis of un-symmetric pile groups:

Use any configuration of piles
Allows to add, move or delete piles as required, useful to review results of as-built pile deviations
Analysis is performed for axial force plus moments in both directions
Piles can have diferent compression and tension capacity
Results include stress contours, indvidual pile results, center of pile group